Use zones to specify where your wireless sensor is located.
The big advantage of wireless sensors = they measure at plant level and are movable. To properly interpret the measurements, it’s important to keep your data organized. You can link a specific area in your greenhouse ( = a zone) to your sensor, so you always know exactly where and when measurements were taken.
Add your sensor to a zone
- Select your sensor from the Data source page
- Go to the tab 'Zone'
- Click current zone and select the right one. No zone yet to select? Read below how to add a new zone.
- In the zone history you see when the sensor was added to a new zone
Add zones to your organization
Your zones management is organization based, what you add here will be visible to your colleagues as well.
- a. While adding a zone to a sensor you can click + Add new zone, to go to the zone management page.
b. Or navigate to your initials/photo in the top right corner, click Organization settings and go to 'Zones'. - Here you can add a new zone, by typing in a name for the Zone & select the right Site.
- Click on Create
- A new zone is added to the list, which you can edit or delete* if needed.
*Note: you can not delete a zone to which sensors are connected.