
Bauke Visser
- Total activity 26
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 19
Activity overview
Latest activity by Bauke Visser-
Bauke Visser created an article,
How to install the 30MHz Connect
The 30MHz Connect gives power to the wireless sensor and sends data to the 30MHz Gateway. When you install the 30MHz according to this article, it is waterproof, dustproof, and transfers data in th...
-
Bauke Visser created an article,
How to clean the probes of your substrate moisture sensors
Are you questioning the readings of the soil moisture sensors? Cleaning the probes could improve the accuracy of the measurements. Metergroup advises cleaning each probe using mild liquid dish soap...
-
Bauke Visser created an article,
VWC calculation tool
Need help calculating the value of VWC, the water volume changes according to the VWC value or pot volume? Please use our online calculator to calculate the: Volume of the slab, pot or container E...
-
Bauke Visser created an article,
My substrate moisture sensor gives an error, why can’t I read out ECw?
Via the sensor menu you can examine the status of the sensor. In case of a warning or error a yellow triangle with an exclamation mark would be visible under the status tab. Hovering over the excla...
-
Bauke Visser created an article,
I have multiple substrate sensors, they seem to differ from each other. How can I overcome this?
Please check the chosen calibration profile, they have to be the same for each sensor to be able to compare them with each other. If the difference still exists, try cleaning the sensor prongs ca...
-
Bauke Visser created an article,
How is EC (ECb & ECw) measured by the Substrate Moisture Sensor?
The Substrate Moisture sensor (Teros12) from Metergroup measures the electrical conductivity (EC) of soil and substrate. In the platform, you will find ECb (Bulk EC) and ECw (Pore EC). ECb is the m...
-
Bauke Visser created an article,
How do I install the Substrate Moisture Sensor?
Correct installation of your Substrate Moisture sensor will make sure that your data will not be affected by the installation. Poor installation can potentially cause accuracy loss greater than 10%...