Natasha
- Total activity 247
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 4
- Subscriptions 163
Activity overview
Latest activity by Natasha-
Natasha created an article,
Best practice for moisture sensor placement in soil or substrate.
The values measured by the sensors are dependent on how they are installed. Even if the sensors are installed in the same soil type, they will show slightly different measurements. The soil will ab...
-
Natasha created an article,
How to setup your 30MHz wireless network
The 30MHz network is wireless and is generated by the 30MHz Gateway. Read this article to understand how you could set up your 30MHz wireless network setup. This article explains: Network range Ne...
-
Natasha created an article,
What is the correct sensor depth for my crop?
Application of irrigation water should be limited to an amount that will penetrate only to the effective root zone depth. Applications in excess of this amount will result in waste of water and add...
-
Natasha created an article,
How to install your Irrigation Management package
This article explains how to install the hardware from the Irrigation Management package. In this article: Content of the Irrigation Management packageInstall the 30MHz GatewayInstall the mounting ...
-
Natasha created an article,
How to set up your RTR widget
After installing your RTR package, you are ready to set up your RTR widget. Note: this widget can only be used if you have Light and Temperature data in your platform. In this article: RTR widget ...
-
Natasha created an article,
How to install the RTR package?
This article explains how to install the sensors from the RTR package. If you need to install the Connect and/or 30MHz Gateway, read the following article first: How to install the 30MHz hardware. ...
-
Natasha created an article,
How to install the Vented Temperature & Humidity sensor?
This article explains how to install the Vented Temperature & Humidity sensor. If you need to install the Connect and/or 30MHz Gateway, read the following article first: How to install the 30MHz ha...
-
Natasha created an article,
How to install the PAR sensor?
This article explains how to install the PAR sensor. If you need to install the Connect and/or 30MHz Gateway, read the following article first: How to install the 30MHz hardware. Take the following...
-
Natasha created an article,
Which calibration profiles are available for Substrate Moisture sensors?
30MHz has multiple calibrations provided in the platform. Click here to find out how to set the calibration for your sensor in the platform after choosing the calibration that suits best for your s...
-
Natasha created an article,
How to use the Substrate Moisture sensors?
30MHz connected the moisture sensors from Metergroup. The sensors are used to measure the state of the substrate. We will explain how to use the substrate moisture sensor in this article. In this ...